A Regulator is built to run offshore in real sea conditions. Your helm pad should be too.
Already know the size you want? Enter it and we'll cut it. Want it fitted to your console? Tell us your Regulator and we'll size the pad to your helm. Either way, you approve the drawing before we cut, and it ships from our Prospect, CT shop.
Design Your Regulator Helm Pad →
Real Regulator helm pads, CNC-cut and engraved in our Prospect, CT shop.
Your size or your Regulator: we cut to either
Most owners already know the footprint they want at the wheel. Put your numbers in the studio, up to 65″ × 28″, and we cut to them exactly.
Rather fit the helm itself? Start with your boat. Every Regulator helm is sized to its hull and console layout, so a stock pad won't sit right. We cut to the helm you actually run, with no trimming on the dock and no gaps.
Your logo, your artwork
Run the Regulator logo, add a marlin, put your boat's name on it, or all three. It's engraved right into the foam, so nothing peels or fades.
Built for the helm you stand at every trip
Stand longer, hurt less
16mm dual-density PE/EVA foam takes the pounding off your knees and back on the long run to the fishing grounds. Want it firmer or thinner? Choose 6, 12, 16 or 20mm.
Grip when it's soaked
Non-slip traction that holds when spray, rain and fish slime hit the helm.
The Regulator logo, engraved
Add the Regulator mark, your boat's name or both, cut right into the foam. It won't peel, fade or wash off.
Your colors, your pattern
Pick your top and bottom colors from the color guide, then finish with teak lines or a clean perimeter line.
Stick it or remove it
Genuine 3M marine-grade adhesive for a permanent install, or removable rubber backing if you want to take it with you.
Made in Connecticut
Every pad is CNC-cut to order in our Prospect, CT shop and shipped nationwide.
Not sure of your size?
Got a rectangle in mind? Measure the area you stand in and enter length × width in the studio. Helm has curves, footrests or cutouts? Use AquaScan: place the reference targets, send photos, and we'll map your helm before we cut. Questions? Call 203-580-8080.
Long runs to the canyon? Finish the cockpit with matching coaming bolsters and a custom dash pad.
Ready to upgrade your Regulator helm?
Enter your size or pick your boat, choose your colors and add the Regulator logo in the studio. Rated 5.0 on Google by the boat owners we've cut for.
Doing more than the helm? Get your whole deck quoted.
AquaGrip CT is an independent fabricator and is not affiliated with or endorsed by Regulator Marine. Brand names and logos appear on pads made to order for their owners.